Synaccess Networks NP-0801DTM - Manual (Page 236)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 236
#SGACTCFG: ,,,
where:
‐ as before
‐ as before
‐ as before
‐ as < urcmode > before
Test command reports supported range of values for , , and .
Syntax
Command Command type
AT#SGACTCFG=,,[,[,]] Execute
AT#SGACTCFG? Read
AT#SGACTCFG=? Test
Parameters and Values
PDP context identifier. See +CGDCONT.
1‐5 Numeric parameter which specifies a particular PDP context definition.
Numeric parameter which specifies the maximum number of context activation
attempts in case of activation failure. Range is 0 – 15.
0 Disable the automatic activation/reactivation of the context. Default: 0.
Numeric parameter which specifies the delay in seconds between an attempt and
the next one. Range is 180 – 3600.
URC presentation mode.
0 Disable unsolicited result code. Default: 0.
1 Enable unsolicited result code, after an automatic activation/reactivation, of the
local IP address obtained from the network. It has meaning only if =1. The
unsolicited message is in the format:
#SGACT:
reporting the local IP address obtained from the network.
Notes
„
The URC presentation mode is related to the current AT instance only. Last setting is
saved for every instance as extended profile parameter. You cannot restore it even if the multiplexer control
channel is released and set up, back and forth.
„
and setting are global parameter saved in non‐volatile memory.
„
If the automatic activation is enabled on a context, then you cannot use the command AT#SCFG to modify the
association between the context itself and the socket connection identifier. If the socket is not connected you
can modify all the other parameters of command AT#SCFG.