Synaccess Networks NP-0801DTM - Manual (Page 31)

HAYES COMPLIANT AT COMMANDS
31 HSPA+ AT Commands Reference Guide
DTE Modem Interface Control
Command Echo E
Set command enables or disables the command echo.
Syntax
Command Command type
ATE[] Set
Parameters and Values
0 Disables command echo.
1 Enables command echo, hence command sent to the device are echoed back to
the DTE before the response is given. Default: 1.
Notes
„
If parameter is omitted, the command has the same behavior as ATE0.
„
Reference: V.25ter.
Quiet Result Codes Q
Set command enables or disables the result codes.
Syntax
Command Command type
ATQ[] Set
Parameters and Values
0 Enables result codes. Default: 0.
1 Disables result codes.
2 Disables result codes. Only for backward compatibility.
Notes
„
After issuing either ATQ1 or ATQ2 every information text transmitted in response to commands is not affected.
„
If parameter is omitted, the command has the same behavior as ATQ0.
Examples
After issuing ATQ1 or ATQ2
AT+CGACT=?
+CGACT: (0-1) nothing is appended to the response