Synaccess Networks NP-0801DTM - Manual (Page 175)

CUSTOM AT COMMANDS
175 HSPA+ AT Commands Reference Guide
Parameters and Values
0 Disable the presentation of the #MWI URC/
1 Enable the presentation of the #MWI URC each time a new message waiting
indicator is received from the network and, at startup, the presentation of the
status of the message waiting indicators, as they are currently stored on SIM.
The URC format is:
#MWI: ,[,]
where:
0 – Clear. Deleted one of the messages related to the indicator .
1 – Set. New waiting message related to the indicator .
1 ‐ either Line 1 (CPHS context) or Voice (3GPP context)
2 ‐ Line 2 (CPHS context only)
3 ‐ Fax
4 ‐ E‐mail
5 ‐ Other
‐ Message counter. Network information reporting the number of
pending messages related to the message waiting indicator .
The presentation at startup of the message waiting indicators status, as they are
currently stored on SIM, is as follows:
#MWI: [,[,][
#MWI: ,[,][...]]]
where:
0 ‐ No waiting message indicator is currently set: if this the case no other
information is reported
1 ‐ There are waiting messages related to the message waiting indicator
.
1 ‐ Either Line 1 (CPHS context) or Voice (3GPP context)
2 ‐ Line 2 (CPHS context)
3 ‐ Fax
4 ‐ E‐mail
5 ‐ Other
‐ Message counter. Number of pending messages related to the message
waiting indicator as it is stored on SIM.
Network Emergency Number Update
Set command enables or disables unsolicited indication of emergency number update.
Read command reports whether the unsolicited indication of network emergency number update is currently
enabled or not, in the format:
#NWEN:
Test command reports the range for the parameter .