Synaccess Networks NP-0801DTM - Manual (Page 26)

HAYES COMPLIANT AT COMMANDS
HSPA+ AT Commands Reference Guide 26
Parameters and Values
0‐1 Profile number. The wireless module can store 2 full configurations. See &W.
Notes
„
Different from command Z, which loads just once the desired profile, the one chosen through command &P
is loaded on every startup.
„
If parameter is omitted, the command has the same behavior as AT&P0.
Store Current Configuration &W
Use this command to store the complete configuration of the device in profile .
Syntax
Command Command type
AT&W[]
Parameters and Values
0‐1 Profile.
Notes
„
If parameter is omitted, the command behaves the same as AT&W0.
Store Telephone Number &Z
Use this command to store the telephone number in the record . The records cannot be overwritten. You
must clear them before rewriting.
Syntax
Command Command type
AT&Z=
Parameters and Values
Phonebook record.
String type, telephone number.
Notes
„
The wireless module has built‐in, non‐volatile memory where you can store 10 telephone numbers, each with a
maximum 24 digits.
„
To delete the record , issue the command AT&Z=.
„
Use the command &N to view the records in the module memory
„
To dial the telephone number stored in the record use the command ATDS=.