Synaccess Networks NP-0801DTM - Manual (Page 227)

CUSTOM AT COMMANDS
227 HSPA+ AT Commands Reference Guide
Examples
Next command opens a socket listening for TCP on port 3500 without.
AT#SL=1,1,3500
OK
Notes
„
If successful, the command returns a final result code OK.
„
If the ListenAutoRsp flag has not been set through the command AT#SCFGEXT (for the specific connId), then,
when a TCP connection request comes on the input port, if the sender is not filtered by internal firewall (see
#FRWL), an URC is received:
+SRING :
You must use #SA command to accept the connection or #SH command to refuse it.
„
If the ListenAutoRSP flag is set when a TCP connection request is received on the local listening port, the
connection is automatically accepted as long as the IP address of the device originating the connection has been
defined in the internal firwewall (see #FRWL.) Once accepted the CONNECT indication is given and the modem
goes into online data mode.
„
When closing the listening socket you do not need to specify the value.
Socket Listen UDP #SLUDP
This command opens or closes a socket listening for an incoming UDP connection on a specified port.
Read command returns all the actual listening UDP sockets.
Test command returns the range of supported values for all the subparameters.
Syntax
Command Command type
AT#SLUDP=,,
AT#SLUDP? Read
AT#SLUDP=? Test
Parameters and Values
Socket connection identifier.
1‐6
0 Closes socket listening.
1 Starts socket listening.