Synaccess Networks NP-0801DTM - Manual (Page 297)

GPS AT COMMANDS SET
297 HSPA+ AT Commands Reference Guide
Syntax
Command Command type
$GPSSLSR=
[,[,,
[,,[,[,id> [,]]]]]]]
AT$GPSSLSR? Read
AT$GPSSLSR=? Test
Parameters and Values
0 CPlane.
1 SUPL.
2 Invalid
Note: If is Autonomous the is invalid.
0 Pure MS Assisted ‐ Location estimate from the network (MS Assisted
mode).
1 MS Based ‐ Assistance Data from the network (MS Based mode).
2 MS Assisted Based ‐ Combination of MS‐A and MS‐B modes, location
estimate computed both at UE and Network.
3 Autonomous – Autonomous GPS mode of operation.
Note: If is Autonomous set the to
invalid.
String parameter containing the ID of the LCS‐Client to which the location
estimate is transferred.
Note: is mandatory for A‐GPS. The is
Cplane.
0 MSISDN.
1 Invalid. Default: 1.
Note: and are mandatory for A‐GPS mode.
String parameter containing the address of the GMLC through which the
location estimate is to be sent to the LCS‐Client.
Note: is mandatory in case of A‐GPS.
0 MSISDN.
1 Invalid. Default: 1.
Note: and are mandatory for A‐GPS
mode.
GPS reporting period in seconds. Is sent unsolicited.
0 ‐ 7200 If 0, then a single shot NMEA Message is provided
Value other than 0 sets the period, in seconds, between each NMEA
sentence.
Note: Use AT$GPSNMUN to enable the Unsolicited NMEA sentences.