Synaccess Networks NP-0801DTM - Manual (Page 164)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 164
call, and is displayed as 255.
Chip energy per total wideband power in dBm; for serving cell this is not available
during a call, and is displayed as 255.
UMTS assigned radio channel.
Discontinuous reception cycle length.
Scrambling code.
Note: TA: is reported only for the serving cell.
If the last setting done by #MONI is 7, the Execute command produces a table‐like formatted output, as follows:
„
First row reports the identifying name of the ‘columns’
#MONI: Cell BSIC LAC CellId ARFCN Power C1 C2 TA RxQual PLMN
„
Second row reports a complete set of GSM‐related information for the serving cell:
#MONI: S:
„
3rd to 8th rows report a reduced set of GSM‐related information for the cells in the neighbours:
#MONI: N []
where:
C1 reselection parameter.
C2 reselection parameter.
Other parameters are described earlier.
Note: Currently, AT#MONI=7 is only available in case of GSM network.
Test command reports the maximum number of cells, in the neighbor list of the serving cell excluding it, from
which GSM/UMTS‐related information can be extracted, along with the ordinal number of the current selected
cell, in the format:
#MONI: (,)
where:
Maximum number of cells, in the neighbor list of the serving cell and excluding it,
from which GSM‐related information can be extracted. This value is always 6.
Last setting done with command #MONI.
Syntax
Command Command type
AT#MONI[=[]]
AT#MONI=?
Parameters and Values
GSM network
0‐6 The ordinal number of the cell, in the neighbor list of the serving cell. Default: 0,
serving cell.
7 Special request to obtain GSM‐related information from the whole set of seven
cells in the neighbor list of the serving cell.