Synaccess Networks NP-0801DTM - Manual (Page 187)

CUSTOM AT COMMANDS
187 HSPA+ AT Commands Reference Guide
+GSMCONT: ,,
Test command returns the supported range of values for all the parameters.
Syntax
Command Command type
AT#GSMCONT=
[,,
] Set
AT#GSMCONT? Read
AT#GSMCONT=? Test
Parameters and Values
Context Identifier; numeric parameter which specifies the only GSM context.
0 Note: Issuing #GSMCONT=0 causes the values for context number 0 to become
undefined.
Note: Command not yet implemented.
Protocol type; a string parameter which specifies the type of protocol "IP"
(Internet Protocol).
Phone number of the internet service provider.
Show Address #CGPADDR
Execute command returns either the IP address for the GSM context (if specified) or a list of PDP addresses for the
specified PDP context identifiers.
Test command returns a list of defined s.
Syntax
Command Command type
AT#CGPADDR=[[,[,…]]] Execute
AT#CGPADDR=? Test
Parameters and Values
Context identifier.
0 Specifies the GSM context. See +GSMCONT.
1‐5 Numeric parameter which specifies a particular PDP context definition. See
+CGDCONT command.
Notes
„
If no is specified, the addresses for all defined contexts are returned.
„
Issuing the command with more than 6 parameters raises an error.
„
The command returns only one row of information for every specified , even if the same is present
more than once.
„
The command returns a row of information for every specified whose context is already defined. No row is
returned for a whose context has not been defined yet. Response format is:
#CGPADDR: ,