Synaccess Networks NP-0801DTM - Manual (Page 324)

AUDIO COMMANDS
HSPA+ AT Commands Reference Guide 324
Examples
AT#SPCM=1,0,0
CONNECT
+++
NO CARRIER
Note: After CONNECT, 8Khz 8bit PCM stream has to be sent to serial port
AT#SPCM=2,0,0
CONNECT
+++
NO CARRIER
Note: After CONNECT, 8Khz 8bit PCM stream can be read from serial port.
TeleType Writer #TTY
Set command enables or disables the TTY feature.
Read command returns whether the TTY function is currently enabled or not, in the format:
#TTY:
Test command reports the supported range of values for .
Syntax
Command Command type
AT#TTY= Set
AT#TTY? Read
AT#TTY=? Test
Parameters and Values
0 Disable TTY function Default: 0.
1 Enable TTY function.
Notes
„
The value set by this command is directly stored in non‐volatile memory and does not depend on the specific AT
instance.