Synaccess Networks NP-0801DTM - Manual (Page 60)

3GPP TS 27.007 AT COMMANDS
HSPA+ AT Commands Reference Guide 60
Syntax
Command Command type
AT+CLIP=[] Set
AT+CLIP? Read
AT+CLIP=? Test
Parameters and Values
0 Disables CLI indication. Default: 0.
1 Enables CLI indication.
If enabled the device reports after each RING the response:
+CLIP: ,,””,128,,
where:
‐ String type, phone number of format specified by
‐ type of address octet in integer format
128 ‐ both the type of number and the numbering plan are unknown
129 ‐ unknown type of number and ISDN/Telephony numbering plan
145 ‐ international type of number and ISDN/Telephony numbering plan.
Contains the character "+".
‐ String type, alphanumeric representation of corresponding
to the entry found in phonebook. Character set used is the one selected with
command Select TE character set +CSCS.
0 ‐ CLI valid
1 ‐ CLI withheld by the originator.
2 ‐ CLI is not available due to interworking problems or limitation or originating
network.
Notes
„
The command changes only the reported behavior of the device. It does not change CLI supplementary service
setting on the network.
„
Reference: 3GPP TS 27.007.
Calling Line Identification Restriction +CLIR
Set command overrides the CLIR subscription when temporary mode is provisioned as a default adjustment for all
following outgoing calls. This adjustment can be revoked by using the opposite command. This command refers to
CLIR‐service (GSM 02.81) that allows a calling subscriber to enable or disable the presentation of the CLI to the
called party when originating a call.
Read command gives the default adjustment for all outgoing calls () and also triggers an interrogation of the
provision status of the CLIR service (), where