Synaccess Networks NP-0801DTM - Manual (Page 186)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 186
Syntax
Command Command type
AT#SKIPESC=[] Set
AT#SKIPESC? Read
AT#SKIPESC=? Test
Parameters and Values
0 Does not skip the escape sequence; its transmission is enabled. Default: 0.
1 Skips the escape sequence; its transmission is not enabled.
Notes
„
In case of an FTP connection, the escape sequence is not transmitted, regardless of the command setting.
SIM Detection Mode #SIMDET
Set command specifies the SIM Detection mode.
Read command returns the currently selected SIM Detection Mode in the format:
#SIMDET: ,
where:
SIM detection mode.
SIMIN pin real status.
0 SIM not inserted.
1 SIM inserted.
Test command reports the supported range of values for parameter .
Syntax
Command Command type
AT#SIMDET= Set
AT#SIMDET? Read
AT#SIMDET=? Test
Parameters and Values
SIM detection mode.
0 Ignore SIMIN pin and simulate the status ‘SIM Not Inserted’.
1 Ignore SIMIN pin and simulate the status ‘SIM Inserted’.
2 Automatic SIM detection through SIMIN pin. Default: 2.
GSM Context Definition #GSMCONT
Set command specifies context parameter values for the only GSM context, identified by the (local) context
identification parameter 0.
Read command returns the current settings for the GSM context, if defined, in the format: