Synaccess Networks NP-0801DTM - Manual (Page 130)

3GPP TS 27.005 AT COMMANDS FOR SMS AND CBS
HSPA+ AT Commands Reference Guide 130
„
Use the following table to correct an incoherence problem, due to the fact that it is possible to have
contemporaneous different settings of parameter in different sessions. See #PORTCFG and +CMUX.
settings in different sessions
=1 for session “0”
AND
=2 for at least one of the other sessions URC +CDS is shown only on session “0” and no status
report is stored on SIM
=0 for session “0”
AND
=2 for at least one of the other sessions No URC is shown on any session and no status report is
stored on SIM
New Message Acknowledgement +CNMA
Execute command confirms correct reception of a new message (SMS‐DELIVER or SMS‐STATUS‐REPORT) which is
routed directly to the TE.
Acknowledge with +CNMA is possible only if the +CSMS parameter is set to 1 (+CSMS=1) when a +CMT or +CDS
indication is shown.
If no acknowledgement is given within the network timeout (17 seconds), an RP‐ERROR is sent to the network, the
and parameters of the +CNMI command are then reset to zero (do not show new message indication).
If command is executed, but no acknowledgement is expected, or some other ME related error occurs, final result
code +CMS ERROR: is returned.
The AT command syntax and functionalities are different between SMS PDU Mode and SMS Text Mode.
PDU Mode
For the PDU execute command, either positive (RP‐ACK) or negative (RP‐ERROR) acknowledgement to the
network is possible. Parameter defines which one is sent. Optionally (when is greater than zero) an
acknowledgement TPDU (SMS‐DELIVER‐REPORT for RP‐ACK or RP‐ERROR) may be sent to the network. The
entering of PDU is done similarly as specified in command Send Message +CMGS, except that the SMSC address
field is not present.
PDU mode, test command returns the possible range of values for the .
Text Mode
For execute command, only positive acknowledgement to network (RP‐ACK) is possible.
Text mode, test command returns the OK result code.