Synaccess Networks NP-0801DTM - Manual (Page 151)

CUSTOM AT COMMANDS
151 HSPA+ AT Commands Reference Guide
Value Diagnostic
42 SYNTACTICAL ERROR IN TFT OPERATION
43 UNKNOWN PDP CNTXT
44 SEM ERR IN PKT FILTER
45 SYNT ERR IN PKT FILTER
46 PDP CNTXT WITHOUT TFT ACTIVATED
47 MULTICAST GROUP MEMBERSHIP TIMEOUT
48 RETRY ON NEW CELL BEGIN(if MM cause failure) /ACTIVATION REJECTED BCM VIOLATION(if SM
cause failure)
50 PDP TYPE IPV4 ONLY ALLOWED
51 PDP TYPE IPV6 ONLY ALLOWED
52 SINGLE ADDRESS BEARERS ONLY ALLOWED
63 RETRY ON NEW CELL END
81 INVALID TRANSACTION IDENTIFIER
95 SEMANTICALLY INCORRECT MESSAGE
96 INVALID MANDATORY INFORMATION
97 MSG TYPE NON EXISTENT OR NOT IMPLEMENTED
98 MSG TYPE NOT COMPATIBLE WITH PROTOCOL STATE
99 IE NON_EXISTENT OR NOT IMPLEMENTED
100 CONDITIONAL IE ERROR
101 MSG NOT COMPATIBLE WITH PROTOCOL STATE
111 PROTOCOL ERROR UNSPECIFIED
112 APN RESTRICTION VALUE INCOMPATIBLE WITH ACTIVE PDP CONTEXT
Test command returns OK result code.
Syntax
Command Command type
AT#CEERNET Execute
AT#CEERNET=? Test
Notes
„
Reference: 3GPP 24.008.
Display PIN Counter #PCT
Execute command reports the PIN/PUK or PIN2/PUK2 input remaining attempts, depending on +CPIN requested
password in the format:
#PCT:
where:
Remaining attempts.
0 SIM is blocked.
1‐3 If the device is waiting, SIM PIN or SIM PIN2 is given.
1‐10 If device is waiting, SIM PUK or SIM PUK2 is given.
Test command returns the OK result code.