Synaccess Networks NP-0801DTM - Manual (Page 95)

3GPP TS 27.007 AT COMMANDS
95 HSPA+ AT Commands Reference Guide
Syntax
Command Command type
AT+CAMM=[[,]] Set
AT+CAMM? Read
AT+CAMM=? Test
Parameters and Values
ACMmax value, integer type. The maximum number of home units the subscriber
can consume.
Note: To disable the feature set = 0.
PIN2. If PIN2 is input once after startup, it is not required again.
Notes
„
Reference: 3GPP TS 27.007.
Price per Unit and Currency Table +CPUC
Set command sets the values of Advice of Charge related Price per Unit and Currency Table stored in SIM (PUCT).
The PUCT information can be used to convert the home units (as used in commands +CAOC, +CACM and +CAMM)
into currency units.
Read command reports the current values of and parameters in the format:
+CPUC : ,
Test command returns the OK result code.
Syntax
Command Command type
AT+CPUC=,[,] Set
AT+CPUC? Read
AT+CPUC=? Test
Parameters and Values
String type. 3‐character currency code. For example “LIT”, “L. “, “USD”, “DEM”.
Used character set is the one selected with command +CSCS.
String type, price per unit, dot is used as decimal separator. For example
“1989.27”.
SIM PIN2. If PIN2 is input once after startup, it is not required again.
Notes
„
Reference: 3GPP TS 27.007.
Call Meter Maximum Event +CCWE
Set command enabled and disabled sending of an unsolicited result code +CCWV shortly before the ACM
(Accumulated Call Meter) maximum value is reached. The warning is issued approximately when 30 seconds call
time remains. It is also issued when starting a call if less than 30 seconds call time remains.
Note: The set command responds with an error if the Accumulated Call Meter service is not active in SIM