Synaccess Networks NP-0801DTM - Manual (Page 36)

HAYES COMPLIANT AT COMMANDS
HSPA+ AT Commands Reference Guide 36
Parameters and Values
300
1200
2400
4800
9600
19200
38400
57600
115200 Default: 115200.
230400
460800
921600
Notes
„
Rate can be higher than 115200. Maximum value depends on specific product. Check this value with AT+IPR=?.
„
Reference: V.25ter.
Call Control
Dial D
Execute command starts a call to the phone number given as parameter.
If “;” is present, a voice call to the given number is performed, regardless of the current value of the connection
mode set by +FCLASS command.
Syntax
Command Description
ATD[;] Phone number to be dialed.
ATD>[;] Issues a call to phone number which corresponding alphanumeric
field is ; all available memories are searched for the correct
entry.
If “;” is present a voice call is performed.
‐ alphanumeric field corresponding to phone number; it must
be enclosed in quotation marks. Parameter is case sensitive.
Note: Used character set is the one selected with +CSCS.
ATD>[;] Issues a call to phone number in phonebook memory storage
, entry location (available memories may be queried
with AT+CPBS=?).
If “;” is present a voice call is performed.
Parameters:
‐ phonebook memory storage; it must not be enclosed in
quotation marks.
SM ‐ SIM phonebook