Synaccess Networks NP-0801DTM - Manual (Page 25)

HAYES COMPLIANT AT COMMANDS
25 HSPA+ AT Commands Reference Guide
Select Active Service Class +FCLASS
Use the set command to set the wireless module in specified connection mode. Only voice is supported. All calls
done after you set FCLASS to 8 are voice.
Use the READ command to query the current mode.
Use the TEST command to return all supported values of the parameters .
Syntax
Command Command type
AT+FCLASS=
AT+FCLASS?
AT+FCLASS=?
Parameters and Values
0 Data. Not supported.
8 Voice.
Notes
„
Reference: 3GPP TS 27.007
Default Reset Basic Profile Designation &Y
Use this command to define the basic profiles that load on startup.
Syntax
Command Command type
AT&Y[]
Parameters and Values
0‐1 Profile. The wireless module can store 2 complete configurations See &W. Default: 0.
Notes
„
Different from command Z, which loads just once the desired profile, the one chosen through command &Y
is loaded on every startup.
„
If parameter is omitted, the command has the same behavior as AT&Y0.
Default Reset Full Profile Designation &P
Use this command to specify which full profile is loaded on startup.
Syntax
Command Command type
AT&P[]