Synaccess Networks NP-0801DTM - Manual (Page 73)

3GPP TS 27.007 AT COMMANDS
73 HSPA+ AT Commands Reference Guide
Notes
„
The value set by command is stored in non‐volatile memory. The value does not depend on the specific CMUX
instance.
Mobile Equipment Control
Phone Activity Status +CPAS
Execute command reports the device status in the form:
+CPAS:
where:
Phone activity status.
0 Ready. Device allows commands from TA/TE.
1 Unavailable. Device does not allow commands from TA/TE.
2 Unknown. Device is not guaranteed to respond to instructions.
3 Ringing. Device is ready for commands from TA/TE, but the ringer is active.
4 Call in progress. Device is ready for commands from TA/TE, but a call is in
progress.
Test command reports the supported range of values for .
Syntax
Command Command type
AT+CPAS Execute
AT+CPAS=? Test
Notes
„
Although +CPAS is an Execute command, ETSI 07.07 requires the Test command to be defined.
„
Reference: 3GPP TS 27.007.
Examples
ATD03282131321;
OK
AT+CPAS
+CPAS: 4 A call is in progress.
OK
ATH
OK
Set Phone Functions +CFUN
Set command selects the level of function in the ME.
Read command reports the current setting of .