Synaccess Networks NP-0801DTM - Manual (Page 261)

ENHANCED IP STACK EXTENSIONAT COMMANDS
261 HSPA+ AT Commands Reference Guide
through #GSMCONT.
Format is:
#GDATAVOL: ,,,[#GDATAVOL:
,,,[…]]
2 Reports the total GPRS data counter, since last reset, for the all the set PDP
contexts (that is, all the PDP context with APN parameter set using +CGDCONT)
and the total GSM data counter for the GSM context, if set through #GSMCONT.
Format is:
#GDATAVOL: ,,,[
#GDATAVOL: ,,,[…]]
Reporting parameters are as follows:
PDP context identifier.
0 Specifies the GSM context.
1‐5 Numeric parameter which specifies a particular PDP context definition.
Number of bytes either received or transmitted in the last GPRS (or GSM) session
for PDP context.
Number of bytes transmitted in the last GPRS (or GSM) session for PDP
context.
‐ number of bytes received in the last GPRS (or GSM) session for
PDP context.
Notes
„
Last GPRS and GSM session counters are not saved in non‐volatile memory so they are lost at power off.
„
Total GPRS and GSM session counters are saved in non‐volatile memory.
ICMP Ping Support #ICMP
Set command enables or disables the ICMP ping support.
Read command returns whether the ICMP ping support is currently enabled or not, in the format:
#ICMP:
Test command reports the supported range of values for the parameter.
Syntax
Command Command type
AT#ICMP= Set
AT#ICMP? Read
AT#ICMP=? Test
Parameters and Values
0 Disable ICMP ping support. Default: 0.
1 Enable firewalled ICMP ping support. The module is sending a proper
ECHO_REPLY only to a subset of IP Addresses pinging it. The #FRWL specifies is
subset of IP addresses.
2 Enable free ICMP ping support. The module is sending a proper ECHO_REPLY to
every IP address pinging it.