Synaccess Networks NP-0801DTM - Manual (Page 249)

FTP AT COMMANDS
249 HSPA+ AT Commands Reference Guide
Notes
„
Issue FTPTYPE=0 before successive FTPGET (or FTPGETPKT command) to set binary file transfer type.
„
Setting has effect on successive FTP download.
After successive successfully initiated FTPGET(or FTPGETPKT) command is automatically
reset.
„
Value set for has effect on next data transfer(data port opened by FTPGET or FTPGETPKT).
Then value is automatically assigned to 0 for next download.
Receive Data in Command Mode #FTPRECV
Execute command permits the user to transfer at most bytes of remote file, provided that retrieving
from the FTP server is started with a previous #FTPGETPKT command, onto the serial port.
This number is limited to the current number of bytes of the remote file transferred from the FTP server.
Read command reports the number of bytes currently received from FTP server, in the format:
#FTPRECV:
Test command returns the range of supported values for parameter.
Syntax
Command Command type
AT#FTPRECV= Execute
AT#FTPRECV? Read
AT#FTPRECV=? Test
Parameters and Values
Maximum number of bytes to read.
1‐3000
Notes
„
You must have previously opened FTP data port and started download and buffering of remote file through
#FTPGETPKT command.
„
Issuing #FTPRECV when there is no FTP data port opened raises an error.
„
Data port stays open if socket is temporary waiting to receive data(FTPRECV returns 0 and FTPGETPKT gives a
EOF 0 indication).