Synaccess Networks NP-0801DTM - Manual (Page 208)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 208
0 Disable the single event monitoring. Default: 0.
1 Enable the single event monitoring.
Numeric parameter indicating the type of parameter contained in .
0 value indicates that contains the AT command string to execute when
the related event has occurred. Other values depend from the type of event.
Numeric or string value depending on the value of and on the type
of event.
If is 0, then is a string containing the AT command:
„
It has to be enclosed between double quotes
„
It has to start with the 2 characters AT (or at).
„
If the string contains the character ”, then it has to be replaced with the 3 characters \22.
„
The maximumstring length is 96 characters.
„
If it is an empty string, the AT command is erased.
„
If is VBATT, can assume values in the range 0 ‐ 2.
ƒ if = 1, indicates the battery voltage threshold in the range 0 – 500, where one unit
corresponds to 10 mV (therefore 500 corresponds to 5 V). Default: 0.
ƒ if = 2, indicates the time interval in seconds after that the voltage battery under the
value specified with = 1 causes the event. The range is 0 – 255. Default: 0.
„
If is DTR, can assume values in the range 0 ‐ 2.
ƒ if = 1, indicates the status high or low under monitoring. The values are 0 (low) and 1
(high). Default: 0.
ƒ if = 2, indicates the time interval in seconds after that the DTR in the status specified
with = 1 causes the event. The range is 0 – 255. Default: 0
„
If is ROAM, can assume only the value 0. The event under monitoring is the roaming state.
„
If is CONTDEACT, can assume only the value 0. The event under monitoring is the context
deactivation.
„
If is RING, can assume values in the range 0 ‐ 1.
ƒ If = 1, indicates the numbers of call rings after that the event occurs. The range is 1‐
50. Default: 1.
„
If is STARTUP, can assume only the value 0. The event under monitoring is the module
start‐up.
„
If is REGISTERED, can assume only the value 0. The event under monitoring is the network
registration (to home network or in roaming) after the start‐up and the SMS ordering.
„
If is GPIOX, can assume values in the range 0 ‐ 3.
ƒ if = 1, indicates the GPIO pin number; supported range is from 1 to a value that
depends on the hardware. Default: 1.
ƒ if = 2, indicates the status high or low under monitoring. The values are 0 (low) and 1
(high). Default: 0.
ƒ if = 3, indicates the time interval in seconds after that the selected GPIO pin in the
status specified with = 1 causes the event. The range is 0 – 255. Default: 0.
„
If is ADCH1, can assume values in the range 0 ‐ 3.