Synaccess Networks NP-0801DTM - Manual (Page 110)

3GPP TS 27.007 AT COMMANDS
HSPA+ AT Commands Reference Guide 110
+CGDCONT.
Note: A special form of the Set command, +CGEQREQ=
causes the requested profile for context number to become
undefined.
Note: The current settings are stored in non‐volatile memory.
Note: Set command can modify the 2G QoS according to 3GPP
23.107. See +CGQREQ.
3G Quality of Service Profile (Minimum Acceptable) +CGEQMIN
Set command allows specifying a 3G quality of service profile for the context identified by the (local) context
identification parameter which is checked by the MT against the negotiated profile returned in the
Activate/Modify PDP Context Accept Message.
Read command returns the current settings for each defined context in the format:
[+CGEQMIN: ,,,,bitrate UL>,,,,ratio>,,,delay>,,,indication>]
[+CGEQMIN:…]
Parameters are described as for the set command except:
‐ Traffic class
0 – conversational. If the value is explicitly defined. Otherwise, if the context or the QoS is undefined it is the
default value as undefined.
1 ‐ streaming
2 ‐ interactive
3 – background
‐ Traffic handling priority
0 (default value as undefined)
1…3
If no PDP context is defined, it has no effect and OK result code is returned.
Test command returns as a compound value the type of the current PDP context and the supported values for the
subparameters in the format:
+CGQMIN: ,(list of supported s),
(list of supported s),(list of supported DL>s),(list of supported s),(list of supported bitrate DL>s),(list of supported s),(list of supportedsize>s),(list of supporteds),(list of supportedratio>s),(list of supported s),(list of supported
s),(list of supported s), (list of
supported s), (list of supported indication>s)