Synaccess Networks NP-0801DTM - Manual (Page 312)

AUDIO COMMANDS
HSPA+ AT Commands Reference Guide 312
Notes
„
Ai = 100 is equal to the maximum value of the single tone. Lower values attenuate output to the difference
between 100 and the selected amplitude (ex: Ai = 80 is equal to 100‐80 = ‐20dB).
„
Issuing AT&F1 or AT&Z has the effect to set the parameters with the last saved in non‐volatile memory values
„
Ai = 0 and Fi = 0 are only values for uninitialized parameters and cannot be issued by AT command. Every time
the set command is issued, the unspecified parameters are automatically reset to zero.
„
(Ai,Fi) issuing needs also (Aj,Fj) with j
User Defined Tone SAVE #UDTSAV command
Execute command saves the actual values of frequency and amplitude that are set with #UDTSET.
Test command returns the OK result code.
Syntax
Command Command type
AT#UDTSAV Execute
AT#UDTSAV=? Test
Examples
Current tones are saved in non‐volatile memory.
AT#UDTSAV
OK
User Defined Tone Reset #UDTRST command
Execute command resets to default values for frequency and amplitude, which you can set by using #UDTSET.
Test command returns the OK result code.
Syntax
Command Command type
AT#UDTRST Execute
AT#UDTRST =? Test
Examples
The default value tones are restored in non‐volatile memory.
AT#UDRST
OK