Synaccess Networks NP-0801DTM - Manual (Page 162)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 162
Syntax
Command Command type
AT#AUTOATT=[] Set
AT#AUTOATT? Read
AT#AUTOATT=? Test
Parameters and Values
0 Disables GPRS auto‐attach property.
1 Enables GPRS auto‐attach property. Default: 1.
After the command #AUTOATT=1 is issued—and at every following startup—the
terminal automatically tries to attach to the GPRS service.
Multislot Class Control #MSCLASS
Set command sets the multislot class.
Read command reports the current value of the multislot class in the format:
#MSCLASS:
Test command reports the range of available values for both parameters and .
Syntax
Command Command type
AT#MSCLASS=[[,]] Set
AT#MSCLASS? Read
AT#MSCLASS=? Test
Parameters and Values
Multislot class.
1‐12 Class 7 is not supported.
30‐33 Default: 33.
35‐38 GPRS (EGPRS) class.
0 New multislot class is enabled only at the next detach/attach or after a reboot.
1 New multislot class is enabled immediately, automatically forcing detach/attach
procedure.
Notes
„
DTM multislot class is automatically chosen with maximum allowed value for every GPRS (EGPRS) subset.
Cell Monitor #MONI
#MONI is both a Set and an Execute command.
Set command sets one cell out of seven, in the neighbor list of the serving cell including it, from which extract
GSM /UMTS‐related information.