Synaccess Networks NP-0801DTM - Manual (Page 199)

CUSTOM AT COMMANDS
199 HSPA+ AT Commands Reference Guide
Set TCP Run AT Service Parameter #TCPATRUNCFG
Set command configures the TCP AT RUN service.
Read command returns the current settings of parameters in the format:
#TCPATRUNCFG:
,,,,,,,,,yDelay>
Test command returns the supported values for the parameters
Syntax
Command Command type
AT#TCPATRUNCFG=,,,
,[,[,[,[,
[,]]]]] Set
AT#TCPATRUNCFG? Read
AT#TCPATRUNCFG=? Test
Parameters and Values
Socket connection identifier. Default: 1.
Range 1‐6. This parameter is mandatory.
AT instance used by the service to run the AT command. Range 2 ‐ 3. Default:
2.This parameter is mandatory.
TCP listen port for the connection to the service in server mode. Default: 1024.
Range 1‐65535. This parameter is mandatory.
TCP remote port of the host to connect to, in client mode. Default: 1024. Range
1‐65535. This parameter is mandatory.
String type, IP address of the host.
This parameter can be either:
Any valid IP address in the format: “xxx.xxx.xxx.xxx”.
Any host name to be solved with a DNS query.
This parameter is mandatory. Default: “”.
Note: If username or password are not allowed—see AT#TCPATRUNAUTH—the
connection closes immediately.
In client mode, at boot or after a socket disconnection, this parameter represents
the number of attempts that are made in order to re‐connect to the host.
Default: 0. Range: 0‐5.
In client mode, delay between one attempt and the other. In minutes.
Default: 2. Range: 1‐3600.
0 Disable unsolicited messages.
1 Enable an unsolicited message when the TCP socket is connected or disconnect.
Default: 1.
When unsolicited is enabled, an asynchronous TCP Socket connection is indicated
to TE with unsolicited result code:
#TCPATRUN:
When unsolicited is enabled, the TCP socket disconnection is indicated to TE with
unsolicited result code: