Synaccess Networks NP-0801DTM - Manual (Page 81)

3GPP TS 27.007 AT COMMANDS
81 HSPA+ AT Commands Reference Guide
different from 0 and equal to 0 do not flush the codes, even if was set again to 0 before.
To flush the codes, must be set to 1.
Although it is possible to issue the command when SIM PIN is pending, it answers ERROR if “message” or
“smsfull” indicators are enabled in AT+CIND, because with pending PIN it is not possible to give a correct
indication about SMS status. To issue the command when SIM PIN is pending you must disable “message” and
“smsfull” indicators in AT+CIND first.
„
Reference: 3GPP TS 27.007.
Select Phonebook Memory Storage +CPBS
Set command selects phonebook memory storage that is used by other phonebook commands.
Read command returns the actual values of the parameter , the number of occupied records and
the maximum index number , in the format:
+CPBS: ,,
Note: For =”MC”: if there is more than one missed call from the same number the read command
returns only the last call.
Test command returns the supported range of values for the parameters .
Syntax
Command Command type
AT+CPBS= Set
AT+CPBS? Read
AT+CPBS=? Test
Parameters and Values
“SM” SIM phonebook.
“FD” SIM fixed dialing‐phonebook. Only phase 2/2+ SIM.
“LD” SIM last‐dialing‐phonebook. +CPBF is not applicable for storage.
“MC” Device missed (unanswered received) calls list. +CPBF is not applicable for
storage.
“RC” ME received calls list. +CPBF is not applicable for this storage.
“MB” Mailbox numbers stored on SIM; it is possible to select this storage only if the
mailbox service is provided by the SIM. See #MBN.
“DC” ME last‐dialing‐phonebook. +CPBF is not applicable for this storage.
“ME” ME phonebook. +CPBF is not applicable for this storage.
“EN” SIM emergency numbers phonebook. +CPBW and +CPBF not applicable for this
storage.
“ON” SIM own numbers (MSISDNs) phonebook. +CPBF is not applicable for this storage.
Notes
„
Reference: 3GPP TS 27.007.