Synaccess Networks NP-0801DTM - Manual (Page 179)

CUSTOM AT COMMANDS
179 HSPA+ AT Commands Reference Guide
Parameters and Values
0 All the codec modes are enabled. Default: 0.
1‐31 Sum of integers each representing a specific codec mode:
1 ‐ FR, full rate mode enabled.
2 ‐ EFR, enhanced full rate mode enabled.
4 ‐ HR, half rate mode enabled.
8 ‐ AMR‐FR, AMR full rate mode enabled.
16 ‐ AMR‐HR, AMR half rate mode enabled.
Notes
„
The full rate mode is added by default to any setting in the SETUP message (as specified in ETSI 04.08).
„
The setting 0 is equivalent to the setting 31.
„
The codec setting is saved in the profile parameters.
Examples
To set the codec modes HR (4), EFR (2) and AMR‐FR (8):
AT#CODEC=14
OK
Network Timezone #NITZ
Set command enables or disables (a) automatic date/time updating, (b) Full Network Name applying and (c) #NITZ
URC. Command also changes the #NITZ URC format.
The network sends date and time information after GSM registration or after GPRS attach.
Read command reports whether (a) automatic date/time updating, (b) Full Network Name applying, (c) #NITZ URC
(as well as its format) are currently enabled or not, in the format:
#NITZ: ,
Test command returns supported values of parameters and .
Syntax
Command Command type
AT#NITZ=[[,]] Set
AT#NITZ? Read
AT#NITZ=? Test