Synaccess Networks NP-0801DTM - Manual (Page 176)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 176
Syntax
Command Command type
AT#NWEN=[] Set
AT#NWEN? Read
AT#NWEN=? Test
Parameters and Values
0 Disables unsolicited indication of emergency number update. Default: 0.
1 Enables unsolicited indication of emergency number update.
#NWEN:
1 Number list update from internal ME.
2 Number list update from SIM.
3 Number list update from network.
Packet Service Network Type #PSNT
Set command enables or disables unsolicited result code for packet service network type (PSNT).
Read command reports the and values in the format:
#PSNT: , s
where
0 PSNT unsolicited result code disabled.
1 PSNT unsolicited result code enabled.
Network type.
0 GPRS network.
1 EGPRS network.
2 WCDMA network.
3 HSDPA network.
Note: When the type of network is HSPA, the indication is valid during traffic. It is
not valid in idle because it depends on network broadcast parameters
4 Unknown or not registered.
Test command reports the range for the parameter .
Syntax
Command Command type
AT#PSNT=[] Set
AT#PSNT? Read
AT#PSNT=? Test
Parameters and Values
0 Disable PSNT unsolicited result code. Default: 0.