Synaccess Networks NP-0801DTM - Manual (Page 191)

CUSTOM AT COMMANDS
191 HSPA+ AT Commands Reference Guide
Codec Information #CODECINFO
This command is both a set and an execute command.
Set command enables or disables codec information reports depending on the parameter , in the
specified .
Read command reports and parameter values in the format:
#CODECINFO: ,
Test command returns the range of supported and .
Syntax
Command Command type
AT#CODECINFO[=[,]] Set
Execute
AT#CODECINFO? Read
AT#CODECINFO=? Test
Parameters and Values
0 Numeric format. Default: 0.
1 Text format.
0 Disable codec information unsolicited report. Default: 0.
1 Enable codec information unsolicited report only if the codec changes.
2 Enable short codec information unsolicited report only if the codec changes.
If =1 the unsolicited channel mode information is reported in the following format:
(if =0)
#CODECINFO: ,
(if =1)
#CODECINFO: ,
[,[..[,codec_setn]]]
If =2 the unsolicited codec information is reported in the following format:
#CODECINFO:
The reported values are described below.
Execute command
Execute command reports codec information in the specified .
(if =0)