Synaccess Networks NP-0801DTM - Manual (Page 145)

CUSTOM AT COMMANDS
145 HSPA+ AT Commands Reference Guide
Custom AT Commands
General Configuration AT Commands
Set AT Interface and Trace Interface #PORTCFG
AT#PORTCFG command allows to connect Service Access Points (software anchorage points) to the external
physical ports giving a great flexibility. Examples of Service Access Points: AT Parser Instance #1,#2, #3, MA(Trace),
3G(Trace).
Refer to the appendix for a detailed explanation of all port configurations
Read command reports: value shows the requested configuration that is activated on the next power
off /on of the module; value shows the actual configuration.
#PORTCFG: ,
Test command reports a brief description of the supported ports arrangement solutions. For each
parameter value are displayed, on one row, the allowed couples formed by: a physical port and the logically
connected internal software Access Point (AT, MA). On each row are reported the couples concerning both
configurations: USB cable plugged into USB port or not plugged in.
AT, indicated on each command row result, can be AT0, AT1, or AT2. For a correct interpretation refer to the
tables in this section.
Syntax
Command Command type
AT#PORTCFG=
AT#PORTCFG? Read
AT#PORTCFG=? Test
Parameters and Values
0‐6
Network Selection Menu Availability +PACSP
Read command returns the current value of the parameter in the format:
+PACSP
where:
‐ PLMN mode bit (in CSP file on the SIM)
0 ‐ restriction of menu option for manual PLMN selection.
1 ‐ no restriction of menu option for Manual PLMN selection.
Test command returns the OK result code.