Synaccess Networks NP-0801DTM - Manual (Page 106)

3GPP TS 27.007 AT COMMANDS
HSPA+ AT Commands Reference Guide 106
+CGQREQ: ,,,,,
[+CGQREQ: ,,
,,,[…]]
If no PDP context is defined, it has no effect and OK result code is returned.
Test command returns as a compound value the type of the current PDP context and the supported values for the
subparameters in the format:
+CGQREQ: ,(list of supported s),
(list of supported s),(list of supported s),
(list of supported s),(list of supported s)
Note: Only the “IP” is currently supported.
Syntax
Command Command type
AT+CGQREQ=[[,[,[,[,
[,]]]]]]
AT+CGQREQ? Read
AT+CGQREQ=?
Parameters and Values
PDP context identification. See +CGDCONT command.
Precedence class.
Delay class.
Reliability class.
Peak throughput class.
Mean throughput class.
Note: If a value is omitted for a particular class then this class is not checked.
Notes
„
A special form of the Set command, +CGQREQ= causes the requested profile for context number to
become undefined.
„
Set command can modify the 3G QoS according to 3GPP 23.107. See +CGEQREQ.
„
Reference: 3GPP TS 27.007; GSM 03.60.
Examples
AT+CGQREQ?
+CGQREQ: 1,0,0,3,0,0
OK
AT+CGQREQ=1,0,0,3,0,0
OK
AT+CGQREQ=?