Synaccess Networks NP-0801DTM - Manual (Page 194)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 194
#LANG:
Test command reports the supported range of values for parameter
Syntax
Command Command type
AT#LANG= Set
AT#LANG? Read
AT#LANG=? Test
Parameters and Values
Selected language.
“en” English. Default: “en”.
“it” Italian.
Enable RX Diversity and Set DARP #RXDIV
This command enables or disables the RX diversity and sets the DARP.
Read command reports the currently selected and parameters in the format:
#RXDIV: ,
Test command reports the supported range of values for and
Syntax
Command Command type
AT#RXDIV=[,]
AT#RXDIV? Read
AT#RXDIV=? Test
Parameters and Values
RX diversity.
0 Disable the RX diversity.
1 Enable RX diversity. Default: 1.
0 DARP not supported.
1 DARP phase 1.
2 DARP phase 2 traffic only.
3 DARP always on. Default: 3.
Notes
„
The values set by command are directly stored in non‐volatile memory and do not depend on the specific CMUX
instance.
Set Encryption Algorithm #ENCALG
This command enables or disables the GSM and/or GPRS encryption algorithms supported by the module.