Synaccess Networks NP-0801DTM - Manual (Page 105)

3GPP TS 27.007 AT COMMANDS
105 HSPA+ AT Commands Reference Guide
Syntax
Command Command type
AT+CGQMIN=
[
[,
[,
[,
[,
[,]]]]]]
AT+CGQMIN? Read
AT+CGQMIN=?
Parameters and Values
PDP context identification. See +CGDCONT command.
Precedence class.
Delay class.
Reliability class.
Peak throughput class.
Mean throughput class.
Note: If a value is omitted for a particular class then this class is not checked.
Notes
„
A special form of the Set command, +CGQMIN= causes the requested profile for context number to
become undefined.
„
Set command can modify the 3G QoS according to 3GPP 23.107. See +CGEQMIN.
„
Reference: 3GPP TS 27.007; GSM 03.60
Examples
AT+CGQMIN=1,0,0,3,0,0
OK
AT+CGQMIN?
+CGQMIN: 1,0,0,5,0,0
OK
AT+CGQMIN=?
+CGQMIN: “IP”,(0-3),(0-4),(0-5),(0-9),(0-18,31)
OK
Quality of Service Profile +CGQREQ
Set command allows to specify a Quality of Service Profile that is used when the terminal sends an Activate PDP
Context Request message to the network. It specifies a profile for the context identified by the (local) context
identification parameter, .
Read command returns the current settings for each defined context in the format: