Synaccess Networks NP-0801DTM - Manual (Page 52)

3GPP TS 27.007 AT COMMANDS
HSPA+ AT Commands Reference Guide 52
Parameters and Values
0 Drop DTR ignored but OK result code given. ATH disconnects.
1 Drop DTR and ATH ignored but OK result code given.
2 Drop DTR" behavior according to &D setting. ATH disconnects. Default: 2.
Select Type of Address +CSTA
Set command selects the type of number for further dialing commands (D) according to GSM/UMTS specifications.
Read command returns the current value of in the format: +CSTA:
Test command reports the range for .
Syntax
Command Command type
AT+CSTA=[] Set
AT+CSTA? Read
AT+CSTA=? Test
Parameters and Values
Type of address octet in integer format (refer TS 24.008, subclause 10.5.4.7).
Default is 145, when dialing string includes international access code character "+",
otherwise 129.
Network Service Handling
Subscriber Number +CNUM
Execute command returns the MSISDN—if the phone number of the device is stored in the SIM card—in the
format:
+CNUM: ,,[
+CNUM: ,,[…]]
where:
Alphanumeric string associated to ; Character set used is the one
selected with +CSCS.
String containing the phone number in the format .
Type of number
129 National numbering scheme.
145 International numbering scheme. Contains the character "+".
Test command returns the OK result code
Syntax
Command Command type
AT+CNUM Execute