Synaccess Networks NP-0801DTM - Manual (Page 24)

HAYES COMPLIANT AT COMMANDS
HSPA+ AT Commands Reference Guide 24
V.250 AT Commands
Generic Modem Control
Set to Factory‐Defined Configuration &F
Execute this command to set the configuration parameters to default values specified by the manufacturer. This
includes hardware configuration switches and other manufacturer‐defined criteria.
Syntax
Command Command type
AT&F[] Set
Parameters and Values
Hardware version, a string of no more than 31 characters.
0 Only the factory profile base section parameters are set to default values.
1 Full factory profile restored, that is, the factory profile base section and the
extended section are restored.
Notes
„
If parameter is omitted, the command has the same behavior as AT&F0.
„
Reference: V.25ter.
Soft Reset Z
Execute this command to the base section of the specified user profile and the extended section of the default
factory profile.
Syntax
Command Command type
ATZ[]
Parameters and Values
Hardware version, a string of no more than 31 characters.
0‐1 User profile number.
Notes
„
Any call in progress is terminated.
„
If parameter is omitted, the command has the same behavior as ATZ0.
„
Reference: V.25ter.