Synaccess Networks NP-0801DTM - Manual (Page 75)

3GPP TS 27.007 AT COMMANDS
75 HSPA+ AT Commands Reference Guide
Enter PIN +CPIN
Set command sends to the device a password which is necessary before it can be operated (SIM PIN, SIM PUK, PH‐
SIM PIN, and so on).
If the PIN required is SIM PUK or SIM PUK2, the is required. This second pin, Replace the old
pin in the SIM.
You can use the command to change the SIM PIN by sending it with both parameters and when
PIN request is pending. If no PIN request is pending the command returns an error code and to change the PIN the
command +CPWD must be used instead.
Read command
Read command reports the PIN/PUK/PUK2 request status of the device in the form:
+CPIN:
where:
PIN/PUK/PUK2 request status code.
READY ME is not pending for any password .
SIM PIN ME is waiting for SIM PIN.
SIM PUK ME is waiting for SIM PUK
PH‐SIM PIN ME is waiting for phone‐to‐SIM card password.
PH‐FSIM PIN ME is waiting for phone‐to‐very first SIM card password.
PH‐FSIM PUK ME is waiting for phone‐to‐very first SIM card unblocking password.
SIM PIN2 ME is waiting for SIM PIN2. This is returned only when the last
executed command resulted in PIN2 authentication failure; that is, +CME
ERROR: 17.
SIM PUK2 ME is waiting for SIM PUK2. This is returned only when the last
executed command resulted in PUK2 authentication failure; that is +CME
ERROR: 18.
PH‐NET PIN ME is waiting for network personalization password.
PH‐NET PUK ME is waiting for network personalization unblocking password.
PH‐NETSUB PIN ME is waiting for network subset personalization password.
PH‐NETSUB PUK ME is waiting for network subset personalization unblocking password.
PH‐SP PIN ME is waiting for service provider personalization password.
PH‐SP PUK ME is waiting for service provider personalization unblocking password.
PH‐CORP PIN ME is waiting for corporate personalization password.
PH‐CORP PUK ME is waiting for corporate personalization unblocking password.
Note: Pin pending status at startup depends on PIN facility setting. To change or query the default power up
setting use the command AT+CLCK=SC,,.
Test command returns OK result code.
Syntax
Command Command type
AT+CPIN=[,] Set
AT+CPIN? Read
AT+CPIN=? Test