Synaccess Networks NP-0801DTM - Manual (Page 159)

CUSTOM AT COMMANDS
159 HSPA+ AT Commands Reference Guide
Parameters and Values
Defines how the STAT_LED GPIO is handled.
0 GPIO tied low.
1 GPIO tied high.
2 GPIO handled by Module Software. Default: 2.
3 GPIO is turned on and off alternatively, with period defined by the sum
+ .
Duration of period in which STAT_LED GPIO is tied high while =3.
1‐100 In tenth of seconds. Default: 10.
Duration of period in which STAT_LED GPIO is tied low while =3
1‐100 In tenth of seconds. Default: 10.
Notes
„
Values are saved in non‐volatile memory by command #SLEDSAV.
„
At module boot the STAT_LED GPIO is always tied high and holds this value until the first non‐volatile memory
reading.
„
To have STAT_LED operative, the first time enter AT#GPIO=1,0,2 setting the GPIO1 as alternate function.
Save STAT_LED GPIO Setting #SLEDSAV
Execute command saves STAT_LED setting in non‐volatile memory.
Test command returns OK result code.
Syntax
Command Command type
AT#SLEDSAV Execute
AT#SLED=? Test
SMS Ring Indicator #E2SMSRI
Set command enables or disables the ring indicator (RI) pin response to an incoming SMS message. If enabled, a
negative going pulse is generated on receipt of an incoming SMS message. The duration of this pulse is
determined by the value of .
Read command reports the duration in ms of the pulse generated on receipt of an incoming SM, in the format:
#E2SMSRI:
Note: Value =0 means that the RI pin response to an incoming SM is disabled.
Test command reports the range of supported values for parameter .
Syntax
Command Command type
AT#E2SMSRI=[] Set
AT#E2SMSRI? Read
AT#E2SMSRI=? Test