Synaccess Networks NP-0801DTM - Manual (Page 135)

3GPP TS 27.005 AT COMMANDS FOR SMS AND CBS
135 HSPA+ AT Commands Reference Guide
Note: The order in which the messages are reported by +CMGL
corresponds to their position in the memory storage
Notes
„
Reference GSM 27.005, 3GPP TS 23.040.
Read Message +CMGR
Execute command reports the message with location value from message storage ( is
the message storage for read and delete SMs as last settings of command +CPMS).
Test command returns the OK result code.
Syntax
Command Command type
AT+CMGR= Execute
AT+CMGR=? Test
Parameters and Values
Message index.
The output depends on the last settings of command +CMGF (message format to
be used).
PDU Mode
If there is a message in location , the output has the following format:
+CMGR: ,,
Where
Status of the message.
0 New message.
1 Read message.
2 Stored message not yet sent.
3 Stored message already sent.
String type, alphanumeric representation of or , corresponding to an
entry found in the phonebook; used character set is the one selected with
command +CSCS.
Length of the PDU in bytes.
Message in PDU format according to GSM 3.40.
The status of the message and entire message data unit is returned
Text Mode
If there is a Received message in location the output format is:
+CMGR: ,,,[,,,,,,,]
The information written in italics is present depending on +CSDH last setting.
If there is either a Sent or an Unsent message in location the output format is: