Synaccess Networks NP-0801DTM - Manual (Page 88)

3GPP TS 27.007 AT COMMANDS
HSPA+ AT Commands Reference Guide 88
String type, value indicating day of week for the alarm in one of the
following formats:
“<1..7>[,<1..7>[, … ]]” Sets a recurrent alarm for one or more days in the week; the digits
1 to 7 corresponds to the days in the week. Monday is 1.
“0” Sets a recurrent alarm for all days in the week.
Integer type indicating if the alarm is silent or not.
0 The alarm is not silent.
1 The alarm is silent.
During the "alarm mode" the device does not make any network
scan and does not register to any network and therefore is not able
to dial or receive any call or SMS, the only command that can be
issued to the module in this state is #WAKE. All other command
must not be issued during this state.
Note: You must set the RTC (issuing +CCLK) at least once before you
can issue +CALA with =8.
Notes
„
Reference: ETSI 07.07, ETSI 27.007.
Examples
AT+CALA="02/09/07,23:30:00+00"
OK
Delete Alarm +CALD
Execute command deletes an alarm in the ME.
Test command reports the range of supported values for parameter.
Syntax
Command Command type
AT+CALD= Execute
AT+CALD=? Test
Parameters and Values
0
Notes
„
Reference: 3G TS 27.007