Synaccess Networks NP-0801DTM - Manual (Page 61)

3GPP TS 27.007 AT COMMANDS
61 HSPA+ AT Commands Reference Guide
‐ facility status on the Mobile
0 ‐ CLIR facility according to CLIR service network status
1 ‐ CLIR facility active (CLI not sent)
2 ‐ CLIR facility not active (CLI sent)
‐ facility status on the Network
0 ‐ CLIR service not provisioned
1 ‐ CLIR service provisioned permanently
2 ‐ unknown (for example no network present)
3 ‐ CLI temporary mode presentation restricted
4 ‐ CLI temporary mode presentation allowed
Test command reports the supported values of parameter .
Syntax
Command Command type
AT+CLIR=[] Set
AT+CLIR? Read
AT+CLIR=? Test
Parameters and Values
Facility status on the Mobile.
0 CLIR facility according to CLIR service network status.
1 CLIR facility active. CLI not sent.
2 CLIR facility not active. CLI sent.
Notes
„
This command sets the default behavior of the device in outgoing calls.
„
Reference: 3GPP TS 27.007.