Synaccess Networks NP-0801DTM - Manual (Page 91)

3GPP TS 27.007 AT COMMANDS
91 HSPA+ AT Commands Reference Guide
Automatic Time Zone Update +CTZU
This command enables and disables automatic time zone update through NITZ.
Read command reports the currently selected in the format:
+CTZU:
Test command reports the supported range of values for parameter .
Syntax
Command Command type
AT+CTZU=
AT+CTZU? Read
AT+CTZU=? Test
Parameters and Values
0 Disable automatic time zone update via NITZ. Default: 0.
1 Enable automatic time zone update via NITZ
Notes
„
The command AT+CTZU=1 enables automatic update of the date and time set by AT+CCLK command (not only
time zone). This happens when a Network Identity and Time Zone (NITZ) message is sent by the network. This
command is the ETSI standard equivalent of Telit custom command AT#NITZ=1. If command AT+CTZU=1, or
AT#NITZ=1 (or both) is issued, NITZ message causes a date and time update.
Alert Sound Mode +CALM
Set command selects the general alert sound mode of the device.
Read command returns the current value of parameter .
Test command returns the supported values for the parameter as compound value.
+CALM: (0‐2)
Syntax
Command Command type
AT+CALM= Set
AT+CALM? Read
AT+CALM=? Test
Parameters and Values
0 Normal mode.
1 Silent mode. No sound is generated by the device, except for alarm sound.
2 Stealth mode. No sound is generated by the device.
Note: If silent mode is selected, incoming calls do not produce alerting sounds but
only the unsolicited messages RING or +CRING.