Synaccess Networks NP-0801DTM - Manual (Page 172)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 172
Parameters and Values
0 Disables the automatic call function. Default: 0.
1 Enables the automatic call function from internal phonebook.
2 Enables the automatic call function from “SM” phonebook.
Indicates a position in the currently selected phonebook.
If the extended automatic call function is enabled and &D2 is issued, the
transition OFF/ON of DTR causes an automatic call to the number stored in
position in the selected phonebook.
Notes
„
Type of call depends on the last issue of command +FCLASS
„
Issuing #ACALEXT causes the #ACAL to be changed.
„
Issuing AT#ACAL=1 causes the #ACALEXT to be set to default.
„
It is recommended to NOT use contemporaneously with either #ACALEXT and #ACAL
„
See &Z to write and &N to read the number on module internal phonebook.
Extended Call Monitoring #ECAM
This command enables or disables the call monitoring function in the ME.
Read command reports whether the extended call monitoring function is currently enabled or not, in the format:
#ECAM:
Test command returns the list of supported values for
Syntax
Command Command type
AT#ECAM=[]
AT#ECAM? Read
AT#ECAM=? Test
Parameters and Values
0 Disables call monitoring function. Default: 0.
1 Enables call monitoring function; the ME informs about call events, such as
incoming call, connected, hang up and so on using the following unsolicited
indication:
#ECAM: ,,,,,[,]
where
‐ call ID
‐ call status
0 ‐ idle
1 ‐ calling (MO)
2 ‐ connecting (MO)
3 ‐ active
4 ‐ hold