Synaccess Networks NP-0801DTM - Manual (Page 296)

GPS AT COMMANDS SET
HSPA+ AT Commands Reference Guide 296
Parameters and Values
Horizontal accuracy in meters.
0 – 1800000 0 is highest accuracy. 1800000 is lowest accuracy. Default: 1800000.
Vertical accuracy in meters.
0 ‐ 990 0 is highest accuracy. 990 is lowest accuracy. Default: 990.
Response time in seconds.
0‐14400 0 is the low delay. 14400 is the highest delay. Default: 14400 seconds.
Maximum age of location.
0‐1966020 0 indicates stored location information is not used. Default: 0.
Value 1966020 indicates the maximum tolerable age of the stored location
information.
The valid range of interval for SUPL (Transport protocol) is [0 ‐ 65535]
seconds and [0 ‐ 1966020] seconds for C‐plane (Transport protocol).
Type of location required. Used only in case of C‐Plane.
0 Current location. Default: 0.
1 Current or last known location.
2 Invalid location, indicates parameter is not used.
Navigation profile.
0 Car navigation profile. Default: 0.
1 Personal profile.
2 Low speed profile.
3 Invalid profile, indicates parameter is not used.
Velocity information needed.
0 FALSE.
1 TRUE. Default: 1.
Notes
„
The current setting is stored through $GPSSAV.
Examples
AT$GPSQOS=1800000,990,150,0,0,0
OK
GPS Start Location Service Request $GPSSLSR
Command starts the Receiver in Autonomous or A‐GPS mode.
Read command returns the current settings, in the format:
$GPSSLSR: [,>[,,[,,[,
[, [,]]]]]]
$GPSSLSR: (0-2),(0-3),(40),(0,1),(40),(0,1),(0-7200),(0-255),(0,1)