Synaccess Networks NP-0801DTM - Manual (Page 72)

3GPP TS 27.007 AT COMMANDS
HSPA+ AT Commands Reference Guide 72
Syntax
Command Command type
AT+CCUG=[[,[,]]] Set
AT+CCUG? Read
AT+CCUG=? Test
Parameters and Values
0 Disable CUG temporary mode. Default: 0.
1 Enable CUG temporary mode: it enables to control the CUG information on the air
interface as a default adjustment for all following outgoing calls.
0‐9 CUG index.
10 No index (preferential CUG taken from subscriber data). Default: 10.
0 No information. Default: 0.
1 Suppress Outgoing Access (OA).
2 Suppress preferential CUG.
3 Suppress OA and preferential CUG.
Notes
„
Reference: 3GPP TS 27.007.
Selection of preferred PLMN list +CPLS
Execute command selects a list of preferred PLMNs in the SIM/USIM.
Read command returns the selected PLMN selector from the SIM/USIM.
Test command returns the whole index range supported s by the SIM/USIM.
Syntax
Command Command type
AT+CPLS= Execute
AT+CPLS? Read
AT+CPLS=? Test
Parameters and Values
0 User controlled PLMN selector with Access Technology EFPLMNwAcT, if not found
in the SIM/UICC then PLMN preferred list EFPLMNsel. This file is only available in
SIM card or GSM application selected in UICC.
1 Operator controlled PLMN selector with Access Technology EFOPLMNwAcT.
2 HPLMN selector with Access Technology EFHPLMNwAcT.