Synaccess Networks NP-0801DTM - Manual (Page 235)

CUSTOM AT COMMANDS
235 HSPA+ AT Commands Reference Guide
OK
Give the command specifying total number of bytes as second parameter:
at#ssendext=1,256
> .............................. ; // Terminal echo of bytes sent is displayed here
OK
All possible bytes(from 0x00 to 0xFF) are sent on the socket as generic bytes.
IP Stack Authentication Type #SGACTAUTH
Set command sets the authentication type for IP Stack
This command has effect on the authentication mode used on AT#SGACT or AT#GPRS commands.
Read command reports the current IP Stack authentication type, in the format:
#SGACTAUTH:
Test command returns the range of supported values for parameter .
Syntax
Command Command type
AT#SGACTAUTH= Set
AT#SGACTAUTH? Read
AT#SGACTAUTH =? Test
Parameters and Values
0 No authentication.
1 PAP authentication. Default: 1.
2 CHAP authentication.
Notes
„
The parameter is not saved in NWM (Non‐volatile memory non‐volatile memory).
Context Activation and Configuration #SGACTCFG
Execute command enables or disables the automatic activation/reactivation of the context for the specified PDP
context, to set the maximum number of attempts and to set the delay between an attempt and the next one. The
context is activated automatically after every GPRS Attach or after a NW PDP CONTEXT deactivation if at least one
socket is configured to this context. See AT#SCFG.
Read command reports the state of all the five contexts, in the format:
#SGACTCFG: ,,, CR>
…