Synaccess Networks NP-0801DTM - Manual (Page 209)

CUSTOM AT COMMANDS
209 HSPA+ AT Commands Reference Guide
ƒ if = 1, indicates the ADC pin number; supported range is from 1 to a value that
depends on the hardware. Default: 1.
ƒ if = 2, indicates the ADC High voltage threshold in the range 0 – 2000 mV. Default: 0.
ƒ if = 3, indicates the time interval in seconds after that the selected ADC pin above
the value specified with = 1 causes the event. The range is 0 – 255. Default: 0.
„
If is ADCL1, can assume values in the range 0 ‐ 3.
ƒ If = 1, indicates the ADC pin number; supported range is from 1 to a value that
depends on the hardware. Default: 1.
ƒ If = 2, indicates the ADC Low voltage threshold in the range 0 – 2000 mV. Default: 0.
ƒ If = 3, indicates the time interval in seconds after that the selected ADC pin under
the value specified with = 1 causes the event. The range is 0 – 255. Default: 0.
„
If is DTMFX, can assume values in the range 0 ‐ 2.
ƒ If = 1, indicates the DTMF string; the single DTMF characters have to belong to the
range ((0‐9),#,*,(A‐D)); the maximum number of characters in the string is 15
ƒ If = 2, indicates the timeout in milliseconds. It is the maximum time interval within
which a DTMF tone must be detected after detecting the previous one, to be considered as belonging to the
DTMF string. The range is (500 – 5000). Default: 1000.
Notes
„
DTMF string monitoring is available only if the DTMF decode is enabled. See #DTMF command.
Send Message #CMGS
For both Text mode and PDU mode, Execute command sends a message to the network.
Test command returns the OK result code.
Syntax
Command Command type
AT#CMGS=, Execute. PDU mode.
AT#CMGS=, Execute. Text mode.
AT#CMGS=? Test
Parameters and Values for PDU Mode
Length of the PDU to be sent in bytes, excluding the SMSC address octets.
7‐164
PDU in hexadecimal format—each octet of the PDU is given as two IRA character
long hexadecimal number—and given in one line.
Note: When the length octet of the SMSC address (given in the ) equals zero,
the SMSC address set with command +CSCA is used; in this case the SMSC Type‐of‐
Address octet is not present in the .
If message is successfully sent to the network, then the result is sent in the format:
#CMGS:
where
‐ message reference number; 3GPP TS 23.040 TP‐Message‐Reference in integer
format.
Note: If message sending fails for some reason, an error code is reported.