Synaccess Networks NP-0801DTM - Manual (Page 282)

SIM TOOLKIT COMMANDS
HSPA+ AT Commands Reference Guide 282
#STGI:
where depends upon the ongoing proactive command as follows:
if =1 (REFRESH)
#STGI: ,
where:
0 ‐ SIM Initialization and Full File Change Notification;
1 ‐ File Change Notification;
2 ‐ SIM Initialization and File Change Notification;
3 ‐ SIM Initialization;
4 ‐ SIM Reset
if =5 (SET UP EVENT LIST)
#STGI: ,
where:
‐ hexadecimal number representing the list of events to
monitor (see GSM 11.14):
‐ '00' = MT call
‐ '01' = Call connected
‐ '02' = Call disconnected
‐ '03' = Location status
‐ '04' = User activity
‐ '05' = Idle screen available
‐ '06' = Card reader status (if class "a" is supported)
‐ '07' = Language selection
‐ '08' = Browser Termination (if class "c" is supported)
‐ '09' = Data available (if class "e" is supported)
‐ '0A' = Channel status (if class "e" is supported)
The hexadecimal number is actually a bit mask, where each bit, when set,
indicates that the corresponding event has to be monitored (for example, if
is 0x0001, it means that MT call has to be monitored).
if =16 (SET UP CALL)
#STGI: ,,[],
where:
‐ unsigned integer, used as an enumeration
0 Set up call, but only if not currently busy on another call
1 Set up call, but only if not currently busy on another call, with redial
2 Set up call, putting all other calls (if any) on hold
3 Set up call, putting all other calls (if any) on hold, with redial
4 Set up call, disconnecting all other calls (if any)
5 Set up call, disconnecting all other calls (if any), with redial
‐ string for user confirmation stage
‐ string containing called number
if =17 (SEND SS)
if =18 (SEND USSD)
if =19 (SEND SHORT MESSAGE)
if =20 (SEND DTMF)
if =32 (PLAY TONE)
if =40 (SET UP IDLE MODE TEXT)
#STGI: [,]