Synaccess Networks NP-0801DTM - Manual (Page 238)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 238
PAD Command Features #PADCMD
This command sets features of the pending data flush to socket, opened with AT#SD command.
Read command reports the currently selected in the format:
#PADCMD: mode
Test command reports the supported range of values for parameter .
Syntax
Command Command type
AT#PADCMD= Set
AT#PADCMD? Read
AT#PADCMD=? Test
Parameters and Values
Bit 1:
1 Enable forwarding.
0 Disable forwarding.
Other bits reserved.
Notes
„
Forwarding depends on character defined by AT#PADFWD.
PAD Forward Character #PADFWD
This command sets the char that immediately flushes pending data to socket, opened with AT#SD command.
Read command reports the currently selected and in the format:
#PADFWD: ,mode
Test command reports the supported range of values for and .
Syntax
Command Command type
AT#PADFWD=[,] Set
AT#PADFWD? Read
AT#PADFWD=? Test
Parameters and Values
A number, from 0 to 255, that specifies the asci code of the char used to flush
data.
Flush mode.
0 Normal mode. Default: 0.
1 Reserved.