Synaccess Networks NP-0801DTM - Manual (Page 93)

3GPP TS 27.007 AT COMMANDS
93 HSPA+ AT Commands Reference Guide
Parameters and Values
Loudspeaker volume
0‐max The value of max can be read by issuing the Test command AT+CLVL=?
Notes
„
Reference: 3GPP TS 27.007.
Microphone Mute Control +CMUT
Set command enables or disables the muting of the microphone audio line during a voice call.
Read command reports whether the muting of the microphone audio line during a voice call is enabled or not, in
the format:
+CMUT:
Test command reports the supported values for parameter.
Syntax
Command Command type
AT+CMUT= Set
AT+CMUT? Read
AT+CMUT=? Test
Parameters and Values
0 Mute off, microphone active. Default: 0.
1 Mute on, microphone muted.
Note: This command mutes or activates both microphone audio paths, internal
mic and external mic.
Notes
„
Reference: 3GPP TS 27.007.
Silence Command +CSIL
This command enables or disables the silent mode. When the phone is in silent mode, all signaling tones from MT
are suppressed.
Read command reports the currently selected in the format:
+CSIL:
Test command reports the supported range of values for .
Syntax
Command Command type
AT+CSIL=[]
AT+CSIL? Read
AT+CSIL=? Test