Synaccess Networks NP-0801DTM - Manual (Page 200)

CUSTOM AT COMMANDS
HSPA+ AT Commands Reference Guide 200
#TCPATRUN:
Unsolicited is dumped on the instance that requested the service activation.
Define in minutes the maximum time for a command execution. If timeout
expires the module is rebooted. Default: 5 minutes. Range: 1‐5.
Determines the authentication procedure in server mode.
0 When connection is up, username and password (in this order, each followed by a
carriage return) must be sent to the module before the first AT command.
Default: 0.
1 When connection is up, the user receives a request for username and, if
username is correct, a request for password. Then a message of ”Login
successful” closes authentication phase.
Notes
„
The current settings are stored in non‐volatile memory.
„
To start the service automatically when the module is powered‐on, you must set the automatic PDP context
activation. See AT#SGACTCFG command.
„
The set command returns ERROR if the command AT#TCPATRUNL? returns 1 as parameter or the
command AT#TCPATRUND? returns 1 as parameter.
TCP Run AT Service in Listen Server Mode #TCPATRUNL
Set command enables or disables the TCP AT RUN service in server mode. When this service is enabled, the
module tries to put itself in TCP listen state.
Read command returns the current settings of and the value of in the format:
#TCPATRUNL: ,
where:
Connection status.
0 Not in listen.
1 In listen, or active.
Test command returns the supported values for the parameters
Syntax
Command Command type
AT#TCPATRUNL= Set
AT#TCPATRUNL? Read
AT#TCPATRUNL=? Test
Parameters and Values
0 Service disabled.
1 Service enabled.
Notes
„
If SMSATRUN is active on the same instance—see AT#TCPATRUNCFG—the command returns ERROR.