Synaccess Networks NP-0801DTM - Manual (Page 55)

3GPP TS 27.007 AT COMMANDS
55 HSPA+ AT Commands Reference Guide
at+creg?
+CREG: 0,2
OK
at+creg?
+CREG: 0,1
OK
The MODULE is registered.
at+creg?
+CREG: 0,1
OK
Operator Selection +COPS
Set command tries to select and register the GSM network operator.
Read command returns current value of ,, and in format . If no operator is
selected, , and are omitted.
+COPS: [, , ,< AcT>]
Test command returns a list of quadruplets, each representing an operator present in the network.
The quadruplets in the list are separated by commas:
+COPS: [list of supported ( ,=0)>,,
=2)>,< AcT>)s][,,(list of supported s),
(list of supporteds)]
where
Operator availability.
0 Unknown.
1 Available.
2 Current.
3 Forbidden.
Access technology selected.
0 GSM.
2 UTRAN.
Note: Because this command requires network scan, it may take a few second to return the output.
Syntax
Command Command type
AT+COPS=[[,[,[,< AcT>]]]] Set
AT+COPS? Read
AT+COPS=? Test